Chinese Version

CANmodul-592
-8051-compatible SBC with CAN interface

SBC MODULE FEATURES

  • Philips P80C592 (16MHz) controller in QFP (optional PLCC) package with on-chip 2.0A Basic CAN
  • 32 (to 160)KB SRAM, with optional battery-buffer
  • 128 (to 512) KB Flash supporting on-board Flash programming via RS-232 with PHYTEC FlashTools
  • optional 32KB EEPROM
  • All controller ports & signals extend to standard-width (2.54mm) pins aligning three edges of the board
  • software-configurable memory mapping (no soldering of jumpers is required)
  • 24x parallel, bi-directional I/Os
  • RS-232 serial interface
  • PCA 82C250 or SI 9200 CAN transceiver
  • flexible address decoding
  • 8-channel A/D converter with 10-bit resolution
  • 2x PWM Outputs with 8-bit resolution
  • Timer/Event Counter with four Capture Registers
  • Watchdog Timer
  • 3x free Chip-Select signals
  • operates within a standard temperature range of 0 to 70 degrees C

SBC Module Description

The CANmodul-592 is an extension of the miniMODUL-535 that is based on the Philips 80C592 single-chip microcontroller. The 80C592 is pin and instruction set compatible to the 80C535 and other 8051-family derivatives. However, it offers such supplemental integrated features as an I2C bus, 24 parallel, bi-directional I/Os; an 8-channel ADC with 10-bit resolution; two PWM-outputs with 8-bit resolution and a Watchdog Timer.

The controller is augmented by 32KB external SRAM and 128KB external Flash. User code is directly downloaded into the Flash via RS-232 with help of the included PHYTEC FlashTools firmware. The module communicates by means of an RS-232 transceiver, operates within a standard industrial temperature range of 0 to 70 degrees C and requires a low 5V/100 mA power source.

 

 The 10th Floor, Quantum Plaza, No. 27, Zhichun Road, Haidian District, Beijing, 100083, P.R. China
Tel: +86-10-82357579, 82357580, 82357576

Fax: +86-10-82357574
info@mcu-world.com