|
-High
Speed 16-bit SBC Offering CAN & Ethernet
|
|
SBC
MODULE FEATURES
- SBC
in subminiature dimensions (60 x 53 mm) according to low EMI phyCORE
specifications
- populated
with various 144-pin C167Cx and ST10 family 16-bit microcontroller
- -Infineon
C167CS with dual on-chip Full CAN 2.0B
- -STMicro
ST10F269 with dual on-chip Full CAN 2.0B and 256 KB on-chip Flash
- Cirrus
Logic CS8900A Ethernet controller
- controller
and board-level signals extend to two 100-pin high-density (0.635mm)
Molex connectors on the underside of the board
- on-board
memory:
- -SRAM:
512KB to 1MB with 15ns access
- -Flash:
256KB to 2MB
- -Serial:
4 to 32KB EEPROM (optional FRAM)
- 16-bit
demultiplexed mode
- 24-channel
A/D converter with 10-bit resolution if populated with the C167CS
(16-channel if populated with the ST10F269)
- battery-buffered
serial Real-Time Clock
- RS232
transceiver
- UART
supports additional on-board asychronous serial interface (supporting
all modem signals) via second RS232 transceiver
- dual
Full 2.0B CAN via 82C251 transceivers
- MTBF=941,282
hour
|
 |
SBC
Module Description
The
phyCORE-167/ST10 HS/E (High-Speed Ethernet) supports various 144-pin devices
in QFP package from Infineon and STMicroelectronics. The module offers
up to 1MB external SRAM with 15ns access time, 2MB external Flash and
supports on-board in-system Flash programming(ISP). If populated with
the C167CS or the ST10F269, the module offers an dual Full 2.0B CAN. If
populated with the ST10F269, the module offers an additional 256KB on-chip
Flash. Both
devices provide 111 I/O lines and a supplemental UART for a second serial
(modem-capable) interface. The Cirrus Logic CS8900A controller enables
Ehternet communication with a transmission rate of 10 Mbit/s. The minimal
form factor and enhanced EMI characteristics of the phyCORE render the
module an excellent subassembly to drive networked OEM applications.
|
Rapid
Development Kit
Phytec
Rapid Development Kits provide all necessary ingredients with which
to jump start embedded designs and propel concept to prototype and
finished product:
- phyCORE-C167/ST10
HS/E Single Board Computer module
- phyCORE
Development Board HD200
- Ethernet
adapter
- serial
cable, AC adapter
- Phytec
Spectrum CD including SBC hardware manual, evaluation compiler,
software demos and Controller User's Manual
|
|
Development
Board
Phytec
Development Boards are fully equipped with all mechanical and electrical
components necessary for the speedy and secure start-up and programming
of Phytec Single Board Computer modules:
- Development
Board in EURO-card dimensions (100 x 160 mm)
- 2x
DB-9 sockets for RS-232 interfaces
- 2x
DB-9 plugs for CAN interfaces
- 2x
opto-decoupled CAN transceivers
- address,
data, interfaces and all applicable I/O signals route from module
to dual 160-pin Expansion Bus, enabling connectivity to Add-on
hardware
|
About
C167CS or ST10F269>>>
|
