|
|
SBC
MODULE FEATURES
- 32-bit
Freescale MPC565 PowerPC microcontroller on an advanced PCB layout
in subminiature dimensions (84 x 57 mm) according to low EMI phyCORE
design
- controller
and board-level signals extend to two high-density (0.635mm) 200-pin
Molex connectors on undersides of SBC
- on-board
memory:
- -SRAM:
1 to 16MB flow-through synchronous Burst-RAM 32-bit organiztion,
wait states, 2-1-1-1 burst mode
- -Flash:
2 to 4MB synchronous Burst-Flash, 32-bit organization, 2 to 8MB
standard Burst-Flash, 32-bit organization
- -Serial:
4 to 32 KB I2C EEPROM(alternatively I2C SRAM, I2C FRAM)
- 10
Mbit/s CS8900A Ethernet controller
- I2C
Real-Time clock with calendar and alarm function
- 4
x UART interfaces
- J1850
interface
- 3
x CAN interfaces: 82C251 CAN transceiver for two channels; also
configurable as TTL
- BDM/Nexus
test/debug interface
- industrial
temperature range (-40..~85..C)
- MTBF=1,185,624
hours
|
 |
SBC
Module Description
The
phyCORE-MPC565 module integrates the 32-bit Freescale MPC565 PowerPC microcontroller
on advanced PCB layout. All applicable controller signals extend to two
200-pin, high-density Molex connectors. In addition to the on-chip Flash
(1MB), the phyCORE-MPC565 can be populated with up to 8 MB of asychronous
standard Flash and 16 MB of synchronous Burst-SRAM, addressable without
wait states. The phyCORE-MPC565 is especially suited for applications
requiring processing of calculation-intensive algorithms. The MPC565's
integrated 64-bit Floating Point Unit (FPU) enables hardware-level execution
of elementary operations with single or double precision floating point
numbers. Other controller features supported by the module include three
on-chip CAN controllers; four UARTs; two SPI interfaces; 40 channel 10-bit
A/D converters; two Time/PWM systems and three Time Processing Units that
process microcode independently of the PowerPC core. These features allow
implementation of the phyCORE-MPC565 in a wide range of embedded applications.
|
Development
Board
Phytec
Development Boards are fully equipped with all mechanical and electrical
components necessary for the speedy and secure start-up and programming
of Phytec Single Board Computer modules:
- Development
Board in EURO-card dimensions (100 x 160mm)
- 3.3V
and 2.6V voltage regulators accept 5V DC input voltage
- 2
x RS232, 2 x CAN interfaces
- RJ-45
Ethernet interface
- BDM
interface with "Parallel-to-OCD" converter, Nexus interface
- address,
data, interfaces and all applicable I/O signals route from module
to dual 160-pin Expansion Bus, enabling connectivity to Add-On
hardware
|
|
Rapid
Development Kit
Phytec
Rapid Development Kits provide all necessary ingredients with which
to jump start embedded designs and propel concept to prototype and
finished product:
- phyCORE-MPC565
Single Board Computer module
- phyCORE-MPC565
Development Board
- serial
cable, parallel cable, AC adapter
- Phytec
Spectrum CD including SBC hardware manual, software, demos and
Controller User's Manual
- Metrowerks
CodeWarrior Evaluation Development Studio for PowerPC
|
About
Freescale MPC565>>>
|
